MT2500偶尔断流

xyc9121993

萝卜大侠 发表于 2023-7-1 16:34
有没有尝试过更换网线呢？

尝试过好几根网线了我一开始也以为是网线没插紧的问题，因为有时候重新拔插一下网线可能也好了。最近看日志有时候是某个设备一直在请求dhcp的样子
Thu Aug 10 04:18:09 2023 daemon.info dnsmasq-dhcp[10184]: DHCPACK(br-lan) 192.168.8.123 a8:51:ab:d5:9e:ca keting
Thu Aug 10 04:18:10 2023 daemon.info dnsmasq-dhcp[10184]: DHCPREQUEST(br-lan) 192.168.8.123 a8:51:ab:d5:9e:ca
Thu Aug 10 04:18:10 2023 daemon.info dnsmasq-dhcp[10184]: DHCPACK(br-lan) 192.168.8.123 a8:51:ab:d5:9e:ca keting
Thu Aug 10 04:18:29 2023 daemon.info dnsmasq-dhcp[10184]: DHCPREQUEST(br-lan) 192.168.8.123 a8:51:ab:d5:9e:ca
Thu Aug 10 04:18:29 2023 daemon.info dnsmasq-dhcp[10184]: DHCPACK(br-lan) 192.168.8.123 a8:51:ab:d5:9e:ca keting
Thu Aug 10 04:20:02 2023 daemon.info dnsmasq-dhcp[10184]: DHCPREQUEST(br-lan) 192.168.8.123 a8:51:ab:d5:9e:ca
Thu Aug 10 04:20:02 2023 daemon.info dnsmasq-dhcp[10184]: DHCPACK(br-lan) 192.168.8.123 a8:51:ab:d5:9e:ca keting

xyc9121993

萝卜大侠 发表于 2023-7-1 16:34
有没有尝试过更换网线呢？

内核日志么看不懂了
[   11.594858] mediatek_soc_hnat 15100000.hnat: wan = eth0
[   11.600144] mediatek_soc_hnat 15100000.hnat: lan = eth1
[   11.605419] mediatek_soc_hnat 15100000.hnat: ppd = eth1
[   11.610654] mediatek_soc_hnat 15100000.hnat: gmac num = 2
[   11.616057] mediatek_soc_hnat 15100000.hnat: ppe num = 1
[   11.621861] mediatek_soc_hnat 15100000.hnat: PPE0 entry number = 8192
[   11.638728] mediatek_soc_hnat 15100000.hnat: PPE0 hwnat start
[   11.644544] hnat roaming work enable
[   12.824026] mtk_soc_eth 15100000.ethernet eth0: Link is Down
[   12.862354] MediaTek MT7981 PHY mdio-bus:00: TX-VCM SW cal result: 0x1
[   12.873704] mtk_soc_eth 15100000.ethernet eth1: PHY [mdio-bus:00] driver [MediaTek MT7981 PHY]
[   12.886120] mtk_soc_eth 15100000.ethernet eth1: configuring for phy/gmii link mode
[   12.894182] br-lan: port 1(eth1) entered blocking state
[   12.899477] br-lan: port 1(eth1) entered disabled state
[   12.904928] device eth1 entered promiscuous mode
[   12.912680] br-lan: port 1(eth1) entered blocking state
[   12.917941] br-lan: port 1(eth1) entered forwarding state
[   12.930688] mtk_soc_eth 15100000.ethernet eth0: configuring for fixed/2500base-x link mode
[   12.939133] mtk_soc_eth 15100000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx
[   12.947720] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   13.526296] tertf: br-lan registered, add it
[   13.863010] br-lan: port 1(eth1) entered disabled state
[   23.110804] mtk_soc_eth 15100000.ethernet eth1: Link is Up - 1Gbps/Full - flow control rx/tx
[   23.119285] br-lan: port 1(eth1) entered blocking state
[   23.124546] br-lan: port 1(eth1) entered forwarding state
[   36.422707] mtk_soc_eth 15100000.ethernet eth1: Link is Down
[   36.428477] br-lan: port 1(eth1) entered disabled state
[   38.470817] mtk_soc_eth 15100000.ethernet eth1: Link is Up - 1Gbps/Full - flow control rx/tx
[   38.479349] br-lan: port 1(eth1) entered blocking state
[   38.484610] br-lan: port 1(eth1) entered forwarding state

xyc9121993

顶一顶。我现在设置小米路由器每周重启一次好像断流情况变少了；不过偶尔时有出现；有没有大佬看一看上面的日志，能不能看出是啥问题？